Kia K900: Electric parking brake (EPB)
Applying the parking brake
To apply the EPB (electric parking brake):
1.Depress the brake pedal.
2.Pull up the EPB switch.
Make sure the warning light comes on.
Also, the EPB is applied automatically if the Auto Hold button is on when the Engine Start/Stop Button is OFF position. (for shift by cable)
Also, the EPB is applied automatically when the Engine Start/Stop Button is OFF position.(for shift by wire)
However, if you press the EPB switch after the engine is turned off, the EPB will not be applied.
CAUTION
Do not operate the parking brake / EPB while the vehicle is moving except in an emergency situation.
Releasing the parking brake
To release the EPB (electric parking brake), press the EPB switch in the following condition:
- Set the Engine Start/Stop Button in the ON position.
- Depress the brake pedal.
Make sure the brake warning light goes off.
To release EPB (electric parking brake) automatically:
- Shift lever in P (Park) With the engine running depress the brake pedal and shift out of P (Park) to R (Rear), N (Neutral) or D (Drive).
- Shift lever in N (Neutral) With the engine running depress the brake pedal and shift out of N (Neutral) to R (Rear) or D (Drive).
- Automatic transaxle vehicle
1. Start the engine.
2. Fasten the driver's seat belt.
3. Close the driver's door, engine hood and trunk.
4. Depress the accelerator pedal while the shift lever is in R (Rear), D (Drive) or M (Manual) mode.
Make sure the brake warning light goes off.
✽ NOTICE
- For your safety, you can engage the EPB even though the Engine Start/Stop Button is in the OFF position, but you cannot release it.
- For your safety, depress the brake pedal and release the parking brake manually with the EPB switch when you drive downhill or when backing up the vehicle.
CAUTION
- If the parking brake warning light is still on even though the EPB has been released, have the system checked by an authorized K900 Kia dealer.
- Do not drive your vehicle with the EPB applied. It may cause excessive brake pad and brake rotor wear.
EPB (electric parking brake) may be automatically applied when:
- The EPB is overheated
- Requested by other systems
Disc brakes wear indicator
When your brake pads are worn and new pads are required, you will hear a high-pitched
warning sound from your front brakes or rear brakes. You may hear this sound come
and go or it may occur whene ...
System warning
If you try to drive off depressing the accelerator pedal with the EPB applied,
but doesn't release automatically, a warning will sound and a message will appear.
If the driver's seat ...
See also:
Air bag non-inflation conditions
In certain low-speed collisions the air bags may not deploy. The air bags are
designed not to deploy in such cases because they may not provide benefits beyond
the protection of the seat belts i ...
Securing a child restraint seat with tether anchorage system
Child restraint hook holders are located on the package tray.
This symbol indicates the position of the tether anchor.
1.Route the child restraint seat strap over the seatback.
For vehicles w ...
Glove box
The glove box can be locked and unlocked with the mechanical key of the smartkey
(1).
To open the glove box, push the button (2) and the glove box will automatically
open. Close the glove box a ...