If emergency towing is necessary, we recommend having it done by an authorized K900 Kia dealer or a commercial tow-truck service.
Proper lifting and towing procedures are necessary to prevent damage to the vehicle. The use of wheel dollies or flatbed is recommended.
It is acceptable to tow the vehicle with the front wheels on the ground (without dollies) and the rear wheels off the ground.
If any of the loaded wheels or suspension components are damaged or the vehicle is being towed with the rear wheels on the ground, use a towing dolly under the rear wheels.
When being towed by a commercial tow truck and wheel dollies are not used, the rear of the vehicle should always be lifted, not the front.
CAUTION
Attaching straps to the chasis, suspension or other parts of the body can cause damage.
CAUTION
When towing your vehicle in an emergency without wheel dollies :
1.Set the Engine Start/Stop Button in the ACC position.
2.Place the shift lever in N (Neutral).
3.Release the parking brake.
CAUTION
Failure to place the shift lever in N (Neutral) may cause internal damage to the transaxle.
CAUTION
If the ECS malfunction indicator illuminates when there is no air in the suspension, the vehicle height will be very low, so do not drive the vehicle to protect it from projections on the ground. Take your vehicle to an authorized K900 Kia dealer by towing the vehicle and have the system checked. You should tow the vehicle as shown the picture.
When you load the vehicle onto the tow truck, the loading angle(1) should be smaller than 6°.
Battery replacement
Conventional smart key
A battery should last for several years, but if the smart key is not working
properly, try replacing the battery with a new one. If you are unsure how to use
or replace the ...
Side repeater light bulb replacement
If the light bulb is not operating, have the vehicle checked by an authorized
K900 Kia dealer. ...
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1. The Engine Start/Stop Button must be in the ON position.
2. ...