1.Be sure the vehicle is on level ground.
2.Start the engine and allow it to reach normal operating temperature.
3.Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.
4.Pull the dipstick out, wipe it clean, and re-insert it fully.
WARNING
Radiator hose
Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.
5.Pull the dipstick out again and check the level. The level should be between F and L.
CAUTION
If it is near or at L, add enough oil to bring the level to F. Do not overfill.
Use a funnel to help prevent oil from being spilled on engine components.
Parking Brake & Brake Fluid Warning Light
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.It
illuminates for approximately 3 seconds It remains on if the parking brake i ...
Advanced Vehicle Safety Management (AVSM) OFF Indicator Light
This indicator light illuminates:
Once you set the Engine Start/Stop Button to the ON position. It illuminates
for approximately 3 seconds and then goes off.
When you deactivate the AVSM sy ...
Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System
(BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds about 18.6 mph (30 km/h), t ...