Park the vehicle and stop the engine. Arm the system as described below.
1.Turn off the engine.
2.Make sure that all doors (and trunk) and engine hood are closed and latched.
3. Lock the doors by depressing the door lock button on the transmitter (or smart key).
After completion of the steps above, the hazard warning lights will blink once to indicate that the system is armed.
If any door, trunk or engine hood remains open, the hazard warning lights won’t operate and theftalarm will not arm. After this, if all doors, trunk and engine hood are closed, the hazard warning lights blink once.
Lock the doors by pressing the button of the front outside door handles with the smart key in your possession.
After completion of the steps above, the hazard warning lights will blink once to indicate that the system is armed.
If any door remains open, the hazard warning lights won’t operate and theft-alarm will not arm. Close the door and try again to lock the doors.
If trunk or engine hood remains open, the hazard warning lights won’t operate and theft-alarm will not arm. Close the trunk or engine hood. The hazard warning lights blink once and theftalarm arms.
The theft-alarm system by the key can be activated by an authorized Kia dealer.
If you want this feature, consult an authorized K900 Kia dealer.
Do not arm the system until all passengers have left the vehicle. If the system is armed while a passenger( s) remains in the vehicle, the alarm may be activated when the remaining passenger(s) leaves the vehicle. If any door (or trunk) or engine hood is opened within 30 seconds after the system enters the armed stage, the system will be disarmed to prevent unnecessary alarm.
Engine number
The engine number is stamped on the engine block as shown in the drawing. ...
Overview
Description
The trip computer is a microcomputer- controlled driver information system that
displays information related to driving.
✽ NOTICE
Some driving information stored in the trip co ...
Removable towing hook
1.Open the trunk, and remove the towing hook from the tool case.
2.Remove the hole cover by pressing the lower part of the cover on the front
or rear bumper.
3.Install the towing hook by turning ...