Checking the brake fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake fluid, clean the area around the reservoir cap thoroughly to prevent brake fluid contamination.
If the level is low, add fluid to the MAX level. The level will fall with accumulated mileage. This is a normal condition associated with the wear of the brake linings. If the fluid level is excessively low, have the brake system checked by an authorized K900 Kia dealer.
WARNING
Loss of brake fluid
In the event the brake system requires frequent additions of fluid, the vehicle should be inspected by an authorized K900 Kia dealer.
WARNING
Brake fluid
When changing and adding brake fluid, handle it carefully. Do not let it come in contact with your eyes. If brake fluid should come in contact with your eyes, immediately flush them with a large quantity of fresh tap water. Have your eyes examined by a doctor as soon as possible.
CAUTION
Do not allow brake fluid to contact the vehicle's body paint, as paint damage will result. Brake fluid, which has been exposed to open air for an extended time should never be used as its quality cannot be guaranteed. It should be disposed of properly. Don't put in the wrong kind of fluid. A few drops of mineralbased oil, such as engine oil, in your brake system can damage brake system parts.
142,500 miles (228,000 km) or 114 months
Rotate tires
Inspect air cleaner filter
Inspect fuel lines, fuel hoses and connections
Inspect vapor hose and fuel filler cap
Inspect fuel tank air filter
Inspect vacuum hose
Inspect po ...
Good braking practices
Check to be sure the parking brake is not engaged and that the parking brake
indicator light is out before driving away.
Driving through water may get the brakes wet. They can also get wet whe ...
Seat belt - Driver's 3-point system with emergency locking retractor
To fasten your seat belt:
To fasten your seat belt, pull it out of the retractor and insert the metal tab
(1) into the buckle (2). There will be an audible "click" when the tab locks in ...