Kia K900: Windshield defrosting and defogging
WARNING
Windshield heating
Do not use the 
or
position during cooling operation in
extremely humid weather. The difference between the temperature of the outside air
and that of the windshield could cause the outer surface of the windshield to fog
up, causing loss of visibility. In this case, set the mode selection knob or button
to the 
position and fan speed control
knob or button to the lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.
Air Conditioning refrigerant label
The actual Air Conditioning refrigerant label in the vehicle may differ from
the illustration.
Each symbols and specification on air conditioning refrigerant label means as
below ;
1. Classifi ...
To defog inside windshield
1.Set the fan speed to the desired position.
2.Select desired temperature.
3.Press the defrost button ( ).
4.The air conditioning will be turned on according to the detected ambient temperature
...
See also:
Seat belt warning (for front passenger’s seat)
The front passenger's seat belt warning light will activate to the following
table when the ignition switch is in "ON" position.
*1 The seat belt warning light will go off if the ...
Tripmeter (1)
The tripmeter is the total driving distance since the last tripmeter reset.
- Distance range: 0.0 ~ 9999.9 mi. or km
To reset the tripmeter, press the OK (RESET) button on the steering wheel ...