Kia K900: Front seat adjustment - power
The front seat can be adjusted by using the control switches located on the doors. Before driving, adjust the seat to the proper position so as to easily control the steering wheel, pedals and switches on the instrument panel.
WARNING
The power seat is operable with the ignition OFF. Therefore, children should never be left unattended in the vehicle.
CAUTION
- The power seat is driven by an electric motor. Stop operating once the adjustment is completed, excessive operation may damage the electrical equipment.
- When in operation, the power seat consumes a large amount of electrical power. To prevent unnecessary charging system drain, don’t adjust the power seat longer than necessary while the engine is not running.
- Do not operate two or more power seat control switches at the same time. Doing so may result in power seat motor or electrical component malfunction.
- Forward and backward
- Seatback angle
- Seat cushion height
- Lumbar support (for driver’s seat)
- Cushion length adjustment (for driver’s seat)
Rear seat
(10) Seat sliding forward or backward adjustment with seatback angle adjustment
(11) Easy access button
(12) Front passenger’s seat forward and rearward
(13) Front passenger’s seat back angle
(14) ...
Forward and backward
Push the control switch forward or backward to move the seat to the desired position.
Release the switch once the seat reaches the desired position. ...
See also:
Operating conditions
The indicator on the switch will illuminate when the Blind Spot Detection System
(BSD) switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds about 18.6 mph (30 km/h), t ...
Puddle lamp
When all the doors (and trunk) are locked and closed, the puddle lamp will come
on for about 15 seconds if any of the below is performed.
When the door unlock button is pressed on the smart key. ...
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above about 18.6 mph (30 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of ...